IMPORTANT: GENERATOR START-UP SEQUENCE FOR MPRO 25 / MX3 (MAXFLOW ADVISORY, NOV 12, 2026)
If you run your MPro 25 / MX3 from a portable generator, follow this simple start-up sequence. It greatly reduces the risk of damage to the unit's internal circuit board.
Why it matters
Many users, especially mobile detailers, leave the pressure washer switched on (power button pressed, unit in standby) all day. When the generator is started, especially by remote start, its first start attempt may not produce enough output to power up the pressure washer. How often this happens depends on the quality of the generator and its inverter. The generator then cranks again to finish starting.
This repeated cranking can create a power surge. Because the pressure washer is already switched on and connected, the surge goes straight to the unit and can cause fatal damage to its internal circuit board.
Recommended sequence: generator first, pressure washer second
- Make sure the MPro 25 / MX3 is switched OFF before starting the generator.
- Start the generator and wait until it is fully running and its output is stable.
- Then power ON the MPro 25 / MX3.
At the end of the day: switch the pressure washer off before shutting down the generator, so it isn't left on for the next start.